![]() Physical interface: xe-6/0/0, Enabled, Physical link is Up [edit interfaces set disableĮnable the interface. ![]() [edit interfaces set gigether-options no-loopbackĭisable the interface. [edit interfaces set unit 0 family inet mtu 1500 [edit interfaces set interface xe-6/0/Īssign the logical interface MTU value. [edit interfaces set unit 0 family inetĪssign the physical interface MTU value. [edit interfaces set speed 10gĪdd the logical interface. edit interfaces xe-6/0/0Ĭonfigure the operating mode. To configure a 2-Port 10-Gigabit Ethernet XPIM:Ĭonfigure the interface. For instructions on how toĭo that, see Using the CLI Editor in Configuration The following example requires you to navigate various In increments) and a single connection option for a wide range of Multiple service levels (1-Gigabit Ethernet to 10-Gigabit Ethernet LANs, WANs, and metropolitan area networks (MANs). The 2-Port 10-Gigabit Ethernet XPIM provides interconnects for With CAT6A or CAT7 Ethernet cable for up to 100 meters.Ģ X fiber (SFP+) ports. The copper ports support 10GBASE-T running (SFP+ is a fiber optic transceiver module designedįor 10-Gigabit Ethernet and 8.5 Gbps-fiber channel systems.) The 2-Portġ0-Gigabit Ethernet XPIM provides a front-end interface connectionĢ X copper ports. Interface Module (XPIM) is a 2 x 10GBASE-T / SFP+ Speeds up to 10 billion bits per second over unshielded or shielded Or IEEE 802.3an) is a telecommunication technology that offers data The 10-Gigabit Ethernet (also known as 10GBASE-T Physical interface-ge-2/0/0, Enabled, Physical link ![]() Verify the following information in the command output: Interface flags: SNMP-Traps Internal: 0x0ĬoS queues : 8 supported, 8 maximum usable queuesĬurrent address: 00:22:83:99:ac:f2, Hardware address: 00:22:83:99:ac:f2 Loopback: Disabled, Source filtering: Disabled, Flow control: Enabled, Auto-negotiation: Enabled, Remote fault: Online Link-level type: Ethernet, MTU: 9010, Link-mode: Full-duplex, Speed: 100mbps, BPDU Error: None, MAC-REWRITE Error: None, Physical interface: ge-2/0/0, Enabled, Physical link is Up From operational mode, enter the show interface ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |